| Modell |
VTS-1013-N |
| Equipment parameters |
Overall dimensions |
6567*1420*1520mm |
| Plate size |
70*50mm-300*350mm |
| Number of heating zones |
9 |
| Length of heating zones |
3420 |
| Number of cooling zones |
Upper 3 |
| Cooling method |
Water cooling – external chiller |
| Process edge |
Standard 5mm, customizable |
| Plate height |
25mm on the board, 15mm below the board |
|
| Transmission parameters |
Transmission mode |
Chain |
| Transmission control mode |
Heating zone and vacuum section servo + cooling zone frequency conversion |
| Transmission speed |
200-2400mm/min |
| Höhe der Übertragung |
900±20 |
| Transmission direction |
L-R or R-L |
|
| Vacuum parameters |
Number of vacuum zones |
1 |
| Ultimate vacuum pressure |
10-100pa |
| Vacuum pumping speed |
60 cubic meters/hour, adjustable |
| Minimum cycle for vacuum welding |
25Sec (action time can be set) |
| Release method |
Nitrogen quick release |
| Vacuum chamber operation method |
Servo control |
| Vacuum zone track |
Servo width and narrow adjustment |
| Flux recovery system |
Independent vacuum zone recovery device |
|
| Control parameters |
Kontrollmodus |
PC+Siemens PLC |
| Temperature control mode |
PID+SSR |
| Temperature control range |
Normal temperature -350℃ |
| Temperature control accuracy |
±1℃ |
| Heat-up time |
≤30min |
| Heat conduction mode |
Hot air independent temperature zone circulation, variable frequency speed regulation |
| Startup/normal operation power |
Startup: 45KW, normal operation 15KW |
| Power failure protection |
UPS endurance operation |
| MES data |
Secondary development possible |
|
| Nitrogen device |
Nitrogen filling method |
The whole area is filled with nitrogen, and the vacuum area is sampled. |
| Nitrogen flow rate |
100-1000ppm @35 cubic meters/hour, nitrogen purity 99.999% |
